Solvline Eddy Serial v2.5.1.1 - Manual (Page 79)

Eddy User's Guide
79
ATA112233445566 ◎
ATA ◎
AT+BTSCAN ◎
AT+BTSCAN,n,to ◎
AT+BTSCAN112233445566,to ◎
AT+BTCANCEL ○
+++ ○
AT+SETESC ◎
ATO ●
ATH ●
AT+BTSEC,Auth,Encr ◎
AT+BTLAST? ○ ○
AT+BTMODEn ◎
AT+BTNAME=”Name” ◎
AT+BTKEY=”nnnn” ◎
AT+BTINFO? ○
AT+BTLPM,n ◎
AT+BTSD? ○ ○
AT+BTCSD ◎
AT+BTFP,n ◎
AT+UARTCONFIG,b,p,s,h ◎
AT+BTVER? ○ ○
AT+BTRSSI,n ●
◎ Valid only when Eddy-BT is not connected to other Bluetooth device.
● Valid only when Eddy-BT is connected to other Bluetooth device.
7.1.5 : S-Register
S-registers contain 52 parameters for the Eddy-BT. These are stored in flash memory and the values will be saved
unless hardware reset is executed. The value of S-register can be accessed and changed with ATS command. Some
S-registers not shown below are set to maximize the performance of Eddy-BT. Thus it is not recommended to
change these S-registers.
Change the value of S-register only in Standby status. Turn Eddy-BT off and on.