Solvline Eddy Serial v2.5.1.1 - Manual (Page 82)

Eddy User's Guide
82
S26: Intercharacter Timeout (default 0)
This value describes time interval between characters used to separate the data from serial port. If there is no more
data coming from serial port in this value, data is sent to client.
S23=1 x S26=50 : Timeout-> 50msec
S23=2 x S26=50 : Timeout-> 500msec
S23=3 x S26=3 : Timeout-> 300msec
Inter Character Time Out * Optimal Value(S23 x S26)
50ms 180
100ms 235
200ms 340
* When 10 bytes data are sent every intercharacter timeout, they are sent separately by 10 bytes at the optimal
value. If the intercharater timeout is set below the optimal value, the data will be put together and sent by 20, 30, 40
bytes or more.
S28: Escape Sequence Character (default 43)
The decimal number of the ASCII code of escape sequence character can be controlled. The initial value is 43, the
ASCII code of ‘+’.
S31: Page Timeout (default 20)
This is the timeout in seconds to attempt connection with the ATD command. After this timeout expires, the Eddy-BT
will restart automatically. If this value is 0, Eddy-BT will attempt to connect without restarting
S33: Inquiry Timeout (default 30)
This is the timeout in seconds to execute inquiry scan.
S37: Supervision Timeout (default 5)
This is the timeout to presume disconnection, which is set to 5 seconds initially. The smaller the value becomes, the
more quickly Eddy-BT can detect an abnormal disconnection. But when the communication is suspended, it may be
regarded as disconnection. This value should be greater than the Slave Disconnect Timeout(S57). (Slave unit
depends on the value of master unit.)
S43: COD (default 001F00)
This value describes the sort of the bluetooth device and is editable.
S44: COD Filter (default 0)
This value is used to filter the sort of the bluetooth devices on inquiring. All the bluetooth devices are inquired in case