Preparation for use – Sonics VC5040AT User Manual
Page 7
PREPARATION FOR USE
1.
Mount the converter / probe assembly in a stand. Secure the clamp to the 1 ¼” (32
mm) diameter converter housing only. Do not secure the clamp to any other portion
of the converter / probe assembly.
2.
Connect the converter to the power supply.
NOTE
If the probe is not attached to the converter observe the following:
a.
Check for cleanliness the mating surfaces of the converter
and probe, as well as the threaded stud and hole.
b.
Hand assemble the probe to the converter, and using two
wrenches, tighten securely.
3.
Rotate the AMPLITUDE control fully counterclockwise.
4.
Connect the 24 volt power supply to the ultrasonic power supply.
5.
Plug the 24 volt power supply into the electrical outlet. If the ON/OFF switch
illuminates, depress it to de-energize the unit.
6.
Connect the converter to the liquid delivery system.
7