Sonics 1596 Actuator - Manual (Page 11)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
10
I N S T R U C T I O N M A N U A L • M O D E L 1 5 9 5 / 1 5 9 6
CONNECTIONS
When making the initial connections, make sure all power is disconnected.
1. Connect the air supply source to the press air filter located at the bottom
rear of the control panel, using a hose having a minimum inside diameter
of 1/4 inch (6.4 mm).
2. Connect the RF and base (actuating) cables of the (table top only) press to
the power supply. (Consult your power supply instruction manual for
details.)
3. Check with your electrician if you have any wiring questions.
OPTIONS
A Linear Encoder is available as an option for the 1595 and 1596 models. The
Linear Encoder allows distance-controlled welding in both incremental and
absolute modes.
The Linear Encoder is supplied with a 9-pin male connector that connects to
a matching 9-pin female connector on the power supply (factory installed).
NOTE: Do not strain or
kink the cables. When
going around corners,
allow as wide a bend as
possible. Do not run the
cables parallel to any
power line within a
distance of less than 1
foot (304.8mm).
LINEAR ENCODER
Go To Top Of Document