Sonics 1596 Actuator User Manual
Page 14
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L 1 5 9 5 / 1 5 9 6
13
5. Using the 3/16” (4.7 mm) T-handle wrench provided, loosen (turn
counterclockwise) the two cap screws screws on the hinged converter
housing and open the door.
6. Place the converter / booster / horn assembly in the housing with the horn
facing down. Fit the male brass button connector on the top of converter
into the brass grooved ridge connector in the bottom of the interior housing,
and gently push the assembly up and in so that the booster mounting ring
rests on the lower support ridge.
7. Close the converter housing door and tighten (turn clockwise) the two
socket head cap screws just until they are snug. Do not tighten the horn to
the booster using the door as the upper wrench. Hand-forcing the horn on
and off in this manner can twist the converter wires and cause a failure. If
the horn is not in the correct position to make contact with your material,
loosen the cap screws re-open the converter housing door, and re-position
the converter / booster / horn assembly.
NOTE: When performing
any of the operations
described on this page and
turn on the power supply.
NOTE: If you do not close
the housing door once the
assembly is in place, the
assembly can fall out.
Never tighten the horn to
the booster using the
housing door as the upper
wrench as this may cause
damage to the booster
and/or converter.
Component
Foot-Lbs.
Newton-Meters
Converter / Booster
50 - 55
68-75
Booster / Horn
50 - 55
68-75
Stud
55
75
RECOMMENDED TORQUE REQUIREMENTS
CONVERTER / BOOSTER /
HORN ASSEMBLY
Go To Top Of Document