Sonics 1096 Actuator - Manual (Page 15)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
14
I N S T R U C T I O N M A N U A L • M O D E L S 1 0 9 9 / 1 0 9 6
the horn contacts the part. Tighten the clamps.
4. Loosen the cap screws on the converter housing door and gently rotate the
head and horn as required to ensure proper horn-to-part alignment.
5. Lock the two column clamps, tighten the converter housing door screws,
and then tighten the fixture on the base plate.
6. Check for proper mating of fixture, parts, and horn. If the horn and part are
not in parallel contact, shim the fixture or adjust leveling screws as
required.
7. Set the PRESSURE regulator to a reading of 20 psig (140 kPa/1.4 bar) on
the pressure gauge. (Turn the PRESSURE knob clockwise.)
8. To check that the horn and parts are properly aligned, the horn needs to
be lowered. Read through the Operation instructions on page 16, and then
proceed to lower the horn as detailed. If the horn and parts are not
sufficiently aligned, then repeat steps 4 through 8. However, if you are
working with small, delicate parts, then fine adjustments can be made
using the positive stop adjustment knob as explained on page 15.
FOR THE 1096 PRESS, FOLLOW THE INSTRUCTIONS
BELOW:
The operation of the 1096 actuator is controlled by the automated system.
Rotate the stack assembly as required to ensure proper horn-to-part
alignment. Check for proper mating of the fixture, parts and horn. If the horn
and part are not in parallel contact, shim the fixture or adjust leveling screws
as required.
To check that the horn and parts are properly aligned, the horn needs to be
lowered. If necessary, shim the fixture or adjust the leveling screw again. Fine
adjustments can be made using the positive stop adjustment knob as
explained on the next page.
When the air pressure is
decreased, the converter
housing can drop down to
its limit, so be sure to
either support it or remove
anything in its path.