Sonics GC - Manual (Page 13)

CABLE CONNECTIONS – For GC Models with 400 to 2200
Watts Power:
Located at the rear of the power supply are the cable connections as
illustrated below. (The interconnecting cables will be supplied with your
system.)
❶
J1, a round Lemo cable that connects the welding press or converter to
the power supply.
❷
J2, a control cable that connects the power supply to a trigger source
(press cable or external trigger source.) Refer to wiring diagrams in
Appendix.
❸
The power line cord that plugs into the appropriate electrical outlet.
Once these connections have been made, the power supply is ready for
operation. If applicable, be sure to consult your welding press instruction
manual to insure that all connections on the press side are correct, and
that the press is ready for operation.
Also located at the rear of the power supply are the following:
❹
Optional J5 External I/O
❺
Fuse (0.5 amp - internal low voltage)
➏
Line fuse (based on requirements listed in “Power Specifications” table,
page 9),
❼
Line fuse (based on requirements listed in “Power Specifications” table,
page 9),
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L G X C / G C P O W E R S U P P LY
12
❷
❶
❸
❺
➏
❹
NOTE: Detailed wiring
diagrams are supplied in
the Appendix at the
back of this manual.
❼
Fan
NOTE: To see a list of
converters that can be
connected to the power
supply, see the table on
page 15.