Tactic TTX300 3-Ch SLT - Manual (Page 3)

3
3. If the receiver’s LED fl ashes once and then stays on, the Rx is already
bound to the Tx and you can skip to the next section. Otherwise, push
and hold the receiver’s “BIND” button until its LED glows red and then
turns off after about one second.
4. Release the bind button.
5.
If the binding is successful, the LED will fl ash once and then remain ON.
6. Test for proper Tx / Rx functionality by completing the next section. If it
doesn’t seem the radio has bound properly, repeat steps 1-6 above.
INSTALLATION
Receiver: Mount the receiver as specifi ed in your model’s instructions. As a
guideline, mount in a secure location using double-sided tape. Route the servo
wires so they do not interfere with any moving parts. For boat applications,
it’s highly recommended to wrap the receiver in a balloon or enclose it in a
water-tight box.
Figure 3
(1) Steering
Servo
(B) Battery /
Switch
(2) Throttle
Servo
Link
Button
Link LED
Channel 3
Servos: See the SERVOS AND ACCESSORIES section at the end of this
manual for a full list of optional servos. CENTER THE TRIM DIALS on the Tx.
Mount the servos inside the model and connect the linkages to the servo using
an appropriate length servo arm. Make sure all mechanical linkages are free
of obstructions and can move smoothly. Connect the servos to the receiver as
shown in Figure 3. Turn the transmitter’s trim dials to fi nely adjust the servo’s
center point as needed to match the installation.
Electronic Speed Control (ESC): If using an electronic speed control,
connect it to channel 2 of the receiver (throttle). Center the transmitter’s
throttle trim and follow the ESC instructions for programming.