Ttx300 specifications, Fcc statement – Tactic TTX300 3-Ch SLT User Manual

Page 7

Advertising
background image

7

Tx POWER SWITCH ON BUT SERVOS DO NOT FUNCTION: Tx or Rx
batteries are low or – replace the batteries or check Tx or Rx battery polarity.
Switch harness or ESC is connected incorrectly – check all connections and
the ESC instruction manual
. Rx is not binded to the Tx properly – perform
binding process again
. Rx antenna located too closely to engine, motor,
servos or other moving mechanical parts which might be creating unwanted
electrical noise – relocate the Rx inside the model or relocate the ESC.

INTERFERENCE OR SERVOS GLITCHING: Out of range – operate the
model more closely to the transmitter
. Outside radio interference (pagers,
strong industrial or other commercial transmitters in the area) – check your local
R/C club for confi rmation of dangerous/interfering frequencies in your area.

CONTROL SURFACE MOVES IN THE WRONG DIRECTION: Change the
position of that channel’s reversing switch.

ONLY ONE SERVO GLITCHES: Servo is bad – replace the servo or send to
Hobby Services for repair.

Contact Hobby Services for other problems.

TTX300 SPECIFICATIONS

TRANSMITTER
Channels:
3
Frequencies: 2.403-2.480GHz
Protocol: Tactic SLT
Modulation: FHSS spread spectrum
Input Power: 3.40-7.00V DC, four 1.5V

alkaline or 1.2V NiCd/NiMH
“AA” single cells.

Output Power: <0.1W
Power On Indicator: red LED

RECEIVER
Channels:
3
Receiving Frequencies: 2.403-2.480GHz
Modulation: FHSS spread spectrum
Input Power: 3.40 - 7.00V DC, four “AA”

alkaline, NiCd or NiMH cells

Dimensions: .75 x .55 x 1.4"

(19 x 14 x 35 mm)

Weight: 18 oz (5.2 g)

FCC STATEMENT

This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions.

(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including

interference that may cause undesired operation.

FCC Rf Radiated Exposure Statement: The equipment complies with FCC
Rf radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO
OR TV INTERFERENCE CAUSED BY UNUAUTHORIZED MODIFICATIONS
TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.

Advertising