Tactic TTX300 3-Ch SLT - Manual (Page 6)

6
automatically center (bring to neutral) all servos if the receiver loses signal
communications from the transmitter. When the receiver regains signal it will
automatically resume normal function.
Range Check: The “range” or safe operating distance from the Tx to the Rx is
typically as far as you can clearly see the model. Before operating the model,
perform a simple range check to make sure the transmitter maintains good
radio contact with the receiver within your operating area.
SYSTEM CHECK
●
NEVER allow water or moisture to make contact with the
electronic components inside the transmitter, receiver,
servos, switch harness, etc.! This could lead to failure or
improper functionality of components and poor control of
vehicle which could pose a safety hazard.
●
NEVER operate R/C equipment if you are physically impaired as it could
pose a safety hazard to yourself or others in the area.
●
NEVER allow small children to operate/control model R/C equipment
without the supervision of an adult.
●
NEVER allow the transmitter’s throttle trigger to accidentally be moved
away from the neutral position while the vehicle is powered up.
●
ALWAYS range check the radio system before use.
●
ALWAYS make sure that all transmitter movements operate all servos
properly in the model.
●
Do not store your radio equipment in extremely hot or cold locations, in
direct sunlight, or in locations with high humidity. Store R/C equipment in
a cool and dry location.
●
Do not allow chemicals to come in contact with any parts of the radio
system. Substances such as glow fuel, gasoline, CA glue, etc. could
permanently damage plastic parts of the radio system.
●
If rechargeable batteries were installed in the transmitter, remove the
batteries before placing the radio in long-term storage.
TROUBLESHOOTING
RANGE IS SHORT: Interference – check Rx installation and servo connections.
Low Tx or Rx battery – replace the batteries or recharge if applicable. Crash
damage – send the radio to Hobby Services for repair.
RUN TIME IS SHORT: Low Tx or Rx batteries – replace the batteries. Obstructed
servo linkages causing excess battery drain – free the linkages/pushrods.