TeeJet TASC-6500 - Manual (Page 13)

2-3
98-05019
Rev- 1
TASC 6200/6500
CE & S
TANDARD
V
ERSION
2.4 SETTING APPLICATION RATES
Each TASC channel can maintain a constant, preset application rate. To do this, the operator must enter the desired
application rates.
2.4.1 SETTING C CHANNEL APPLICATION RATE
A. Set the console switches to the following positions:
Power ON
Mode Selector SET-UP
Channel C Product Switch ON (CENTER)
Display Selector CARRIER, APPL. RATE
The display shows the current channel C application rate.
B. Use the INC/DEC switch to set the value displayed to the new desired rate.
C. Repeat with the Channel C Rate set to ALT-RATE. This establishes an alternate rate.
2.4.2 SETTING C CHANNEL PRODUCT DENSITY
TASC needs to know the product density in order to control the application rate of the product accurately. Product
density is entered in pounds per foot
3 (kilograms/tenths of meters 3 ).
A. Set the console switches to the following positions:
Power ON
Mode Selector SET-UP
Channel C Product Switch ON
Display Selector CARRIER, VOL. APPLIED
The display shows the current channel C product density.
B. Use the INC/DEC switch to set the value displayed to the new desired rate.
C. NOTE: If channel C is being used as a liquid control channel, set the Product Density to 1.0
2.4.3 SETTING ALL OTHER APPLICATION RATES
A. Set the console switches to the following positions:
Power ON
Mode Selector SET-UP
Display Selector L & CHEMICALS, APPL. RATE
Channel 1,2,3 or L Product Switch ON (CENTER)
The display shows the current standard application rates for each channel.
NOTE: Whenever a channel is set to the split drive
option, all booms, to be used, must be turned "ON"
and have widths entered before the calibration num-
ber can be changed. If a boom position will not be used
it must be set to 0.