TeeJet TASC-6500 - Manual (Page 24)

24 M-T 96162
999-1511 TASC 6200/6500
6.1.3 SETTING ALL OTHER APPLICATION RATES
A. Set the console switches to the following positions:
Power ON
Mode Selector SET- UP
Display Selector L & CHEMICALS, APPL. RATE
Channel 1,2,3 or L Rate CENTER, ON POSITION
The display will show the current standard application rates (Amount/Acre) for each channel.
B. Use the INC/DEC switch to set the desired rate. Example, 64.0 for 64 Fluid Oz. (2 qts.) per acre.
C. Repeat with the Channel Rate set to ALT-RATE. This will establish an alternate rate.
D. Program the remaining channels in sequence, using the same procedure outlined in steps A
through C above.
6.1.4 SETTING PRODUCT DENSITY, CHANNELS 1, 2 and/or 3
Whenever channels 1, 2 or 3 are set to the non-peristaltic drive mode, the TASC controller demands a
product density value in order to control accurately. It is important to ensure the density is set correctly
for the material you are applying.
A. Set the console switches to the following positions:
Power ON
Mode Selector SET-UP
Display Selector L & CHEMICALS, VOL. APPLIED
Channel 1, 2 or 3 Rate CENTER, ON POSITION
B. Use the INC/DEC switch to set the density. Example cu25.0 for 25.0 pounds per cubic foot.
C. NOTE: If the channel is being used to control a liquid pump in the non-peristaltic mode, set the
density to 1.0. The calibration number (ALT POSITION) will then be ounces discharged per sensor
pulse, times 1000.
NOTE: Set the rates for granular co-applicators as if they
were Lbs/acre. Set the rates for chemical injection pumps
as if they were ounces per acre.