TeeJet LH 1600M - Manual (Page 15)

LH 1600M O PERATORS MANUAL
LH A GRO 15
TESTING SENSORS
If it is suspected that a sensor is not functioning, as it should; the entire system
can be checked as follows:
The LH 1600M TEST is selected thus:
Key Function
Encode the working width to 25 and activate the tramline function.
Is displayed.
1 indicates that the first sensor is being tested. Sensor no. 1 is the fan
RPM sensor.
0 is a counter that counts from 0-99. One is counted each time the
sensor is activated.
The dot indicates if the sensor is active or not.
When a dot appears, the sensor is active.
Press the key again; and sensor no. 2 can be tested.
Is displayed.
Sensor no. 2, metering shaft RPM sensor, is ready for testing.
Press the key again; and sensor no. 3 can be tested.
Is displayed.
Sensor no. 3, implement sensor, is ready for testing.
Press the key again; and sensor no. 4 can be tested.
Is displayed.
Sensor no. 4, hopper sensor, is ready for testing.
Press the key again; and sensor no. 5 can be tested.
Is displayed.
Sensor no. 5, speed sensor, is ready for testing.