TeeJet LH 1600M - Manual (Page 6)

LH 1600M O PERATORS MANUAL
6 LH A GRO
USING THE TRAMLINE MONITOR
Before the LH 1600M tramline monitor can be used, the following values must be
encoded:
1. Working width.
2. Wheel circumference.
3. Minimum RPM for fan warning (if RPM sensor is fitted).
4. Rpm warning for metering shaft
5. Tramline method and interval
The following encodements are described in the following, point for point:
1. WORKING WIDTH ENCODEMENT
Key Function
Pressing this key displays encodement 1, the working width. A new
working width can be encoded using the up/down keys.
NOTE!
The working width is encoded in centimetres allowing for
any overlap.
Pressing this key deletes/resets the working width.