Canon Z5000 - Manual (Page 35)

2
2-9 About Setup
Ensuring the copier connection
Complete the following steps before you configure the ColorPASS and the
workstations that will print to the ColorPASS. A service technician will have
performed some initial installation.
T O PREPARE FOR C OLOR PASS CONFIGURATION :
1. Print a copier test page to make sure the copier is functioning normally.
2. Turn off the copier and connect the interface cable from the copier to the ColorPASS.
3. To confirm this connection, turn on the copier and the ColorPASS and print a Test Page
from the ColorPASS Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the
Functions menu. Choose Print Pages, and then Test Page.
4. With both the copier and the ColorPASS turned off, connect the network cable to the
ColorPASS, as described in Chapter 1.
The network should already be installed and operational.
5. Turn on the copier and then the ColorPASS.
6. Prepare network servers to share ColorPASS user software and to enable networked
users to print to the ColorPASS.
See Chapter 5 for details.
7. Perform ColorPASS Setup as described in Chapter 3.