Canon Z5000 - Manual (Page 92)

4
4-8 Setting up the ColorPASS from a Windows Computer
Network Setup
Network Setup configures the ColorPASS to receive print jobs over the networks that
are used at your site. If the ColorPASS is configured to enable more than one protocol,
it automatically switches to the correct protocol when it receives a print job. When two
network ports are enabled, print jobs can be received over all ports at the same time.
You can view and specify the following network settings in Network Setup:
• Adapters and ports—view currently configured network adapters and port settings
• Protocols—including AppleTalk, IPX/SPX, and TCP/IP
• Print Services—including LPD printing (TCP/IP), NetWare printing (PServer),
Windows print sharing (SMB), HTTP support (WWW), and Port 9100 printing
Adapters/Ports
From local Setup only, the installed network boards are displayed. You cannot change
this information. From remote Setup, you can enable Ethernet or Token Ring. These
options are described in the next section.