Cabletron Systems CSX200 - Manual (Page 38)

Chapter 4: Installation
4-4 CSX200 Installation Guide
Figure 4-2 Installing WPIMs
To install a WPIM, follow these instructions:
• Attach the disposable grounding strap to your wrist (refer to the instructions outlined on the
disposable grounding strap package).
• Remove the CSX200 cover (see Removing the CSX200 Cover on page 4-2).
• Remove the blank faceplate from the appropriate WPIM slot.
• Orient the WPIM as shown in Figure 4-2 , above, and carefully insert the WPIM connector into
the WPIM connector pins on the CSX200.
• Press down firmly on the WPIM until the pins slide all the way into the connector. Ensure that
the WPIM seats flush on the standoffs.
• Secure the WPIM to the three standoffs using the screws supplied.
• Replace the CSX200 cover.
WPIM
WPIM Screws
Standoffs
WPIM
Connector Pins
WPIM
Connector