Cabletron Systems CSX200 - Manual (Page 55)

Investigating Software Configuration Problems
CSX200 Installation Guide 5-11
If TCP/IP Routing,
• Check that TCP/IP Routing is set on and is enabled at the remote end.
• Check that the IP address of the LAN beyond the remote router is correct, as well as the
associated Subnet Mask.
• If the remote router WAN IP address and Subnet Mask are required, check that they have been
specified correctly.
• Check that, if required, the source and remote WAN IP addresses are on the subnetwork.
• Check that you have seeded the routing table, if RIP is not allowed to flow on the WAN link.
• Be sure to reboot if you have made any IP address, control or protocol option changes.