Toa TS-910 Series Manual - Manual (Page 20)

20
5.5. Wired Delegate Units TS-912 and TS-812
[TS-912 Top]
[TS-812 Top]
PUSH
1
2
3
4
5
6
7
PUSH
1
2
3
5
6
7
1. Monitor speaker
Speech signals from other Conference units and
other audio signals from the Central unit are output
from this speaker. (Refer to the table below.)
Model Output signal
TS-912 Base language or Translation language
Note: Switchable by the Monitor selector
switch (11).
TS-812 Base language
Use the right-side Monitor Volume Control (9) to
adjust the volume. No sound is output from the
speaker of the unit in use while speaking.
2. Microphone
Use either the TS-903 (Standard) or TS-904 (Long)
dedicated microphone.
3. Microphone in-use indicator
Lights when the microphone is turned on (for
speech).
4. Voting keys (TS-912 only)
Use these keys to start, end, and cast voting. The
voting status indicator is provided on each key.
5. Speech indicator
Remains lit while the microphone is in use (during
speech). The indicator flashes when the unit is out
of the communications service area.
6. Talk key
When this key is pressed, both the Microphone In-
Use indicator (3) and the Speech indicator (5) light,
and the microphone turns on. Pressing this key
again turns off both indicators and the microphone.
7. Power indicator
Lights when power is supplied from the TS-910
Central unit via the TS-918 Expansion unit.
Note: No microphone is supplied with the TS-912/812.