Cisco 3750 - Manual (Page 32)

2-14
Catalyst 3750 Metro Switch Hardware Installation Guide
OL-9160-02
Chapter 2 Switch Installation
Installing and Removing SFP Modules
• Run the setup program. See the “Completing the Setup Program” section on page C-5 .
• Connect to the front-panel ports. See the “Connecting to the 10/100 Ports” section on page 2-17 and
the “Connecting to an SFP Module” section on page 2-18 to complete the installation.
To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
program or through the network by using Telnet. For configuration information, refer to the switch
software configuration guide or the switch command reference.
Table- or Shelf-Mounting
Follow these steps to install the switch on a table or shelf:
Step 1 Locate the adhesive strip with the rubber feet in the mounting-kit envelope. Attach the four rubber feet
to each of the corners on the bottom of the unit.
Step 2 Place the switch on the table or shelf near an AC power source.
After the switch is mounted on the table, you might need to perform these tasks to complete the
installation, run the setup program, and access the switch:
• Connect to the console port, and start the emulation software. See the “Connecting to the Console
Port” section on page C-3 and the “Starting the Terminal-Emulation Software” section on page C-3 .
• Power on the switch. See the “Connecting to a Power Source” section on page C-4 .
• Run the setup program. See the “Completing the Setup Program” section on page C-5 .
• Connect to the front-panel ports. See the “Connecting to the 10/100 Ports” section on page 2-17 and
the “Connecting to an SFP Module” section on page 2-18 to complete the installation.
To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
program or through the network by using Telnet. For configuration information, refer to the switch
software configuration guide or the switch command reference.
Installing and Removing SFP Modules
These sections describe how to install and remove SFP modules. SFP modules are inserted into
SFP module slots on the front of the switch. These field-replaceable modules provide uplink interfaces.
You can use any combination of SFP modules. Refer to the release notes for the list of SFP modules that
the Catalyst 3750 Metro switch supports. Each port must match the wave-length specifications on the
other end of the cable, and the cable must not exceed the stipulated cable length for reliable
communications. See
Table B-2 on page B-5 for cable specifications.
Use only Cisco SFP modules on the Catalyst 3750 Metro switch. Each SFP module has an internal serial
EEPROM that is encoded with security information. This encoding provides a way for Cisco to identify
and validate that the SFP module meets the requirements for the switch.
For detailed instructions on installing, removing, and cabling the SFP module, refer to your SFP module
documentation.