Trending Accessibility Adjustable fusion shower pan surface mounted on concrete - Manual (Page 7)

Installation Guide
www.trendingaccessibility.com [email protected]
7
for adjustable fusion shower pan surface mounted on concrete
Step 14
Make your final connections to the drain. First
apply a bead of caulk to the underside of the
strainer body. Pass the strainer through the drain
adapter flange, and tighten. Make sure connection
is snug but do not over tighten.
membrane clamp
height adjustment ring
Remove the tile height adjustment ring and membrane clamp and
place to one side; these will be required later in the installation.
Gasket Clamp
Adapter Drain Flange Step 13
You now want to attach the Drain adapter flange
to the Fusion Pan. First apply a bead of caulk to
the underside of the drain adapter flange. Lightly
push the flange into place, and screw it down
using the four ¾” screws provided. Remove any
excess caulk that squeezes out.
Step 15
You will now begin waterproofing the wet room.
BEST PRACTICE: To achieve the best results, we
recommend waterproofing the whole room.
Minimum requirements, shown in these
instructions, show you that you only have to
waterproof the shower zone, which is 6 ½ feet high
and about 2 feet outside of the showering area.
Materials needed for wet room waterproofing.
Step 16
Begin taping the wetroom floor at the interior corners
of the Adjustable Fusion Pan using the corner
pieces of the crack isolation tape provided. Using
a paint brush or trowel, slather liquid waterproofing
into corner, press piece into place, then apply liquid
waterproofing on top. Make sure to smooth out any
creases. Repeat for additional corners.