Triner Scale VP-70 Manual - Manual (Page 30)

Page 6-7
6.2.9 How to reset the Factory Defaults
To reset the VP-70 to its factory defaults follow the steps below.
1. Press the F1 key.
2. Press the SCREEN DOWN key.
3. Press the SERVICE soft key.
4. At the password prompt key in (336699) then press ENTER.
5. Press the SCREEN DOWN key two times.
6. Press the DEFAULTS soft key.
7. Select YES or NO.
8. Confirm the reset to factory defaults by pressing YES if not press NO.
9. The scale will reset all scale parameters to the factory default.
10. Turn the scale off then on to finalize the changes.
6.2.10 How to clear the Favorites List
All of the countries in the favorites list can be cleared at once by following the
instructions below.
1. Press the F1 key.
2. Press the SCREEN DOWN key.
3. Press the SERVICE soft key.
4. At the password prompt key in (336699) then press ENTER.
5. Press the SCREEN DOWN key two times.
6. Press the CLEARFAV soft key.
7. Select YES or NO.
8. Confirm the clearing of the favorites list by pressing YES.
9. The scale will clear out all the countries in the favorites list.
10. Turn the scale off the on to finalize the changes.