Triner Scale VP-70 Manual User Manual
Page 35
Page 7-4
7.3.4 ADD - Memory Accumulator
The ADD function is used to accumulate multiple batches of items placed on the
scale. Press the ADD soft key to accumulate weight and piece data for each
batch.
When items are added to the accumulator MEM will be displayed on the screen
to indicate there are items in memory.
7.3.5 INFO - Weigh Session Information
Press the INFO soft key to get information about a weigh session.
Accum PCS: 0000
Total WT:
PCS / lb:
# 001 Uwt 0.0000
16.1234
Number of
Entries
Unit Weight
INFORMATION
Pieces per
Pound
Accumulated
Pieces
Total Weight
000.0000
• To exit the Information screen press the CLEAR key.
• To reset the data on the Information screen, press and Hold the CLEAR
key until the scale double beeps. Note: This will clear the following:
o Number of Entries
o Total Weight
o Accumulated Pieces
7.3.6 UNIT WT - Entering a Unit Weight
Allows manual unit weight entry. If the unit weight of the piece is known, enter the
value. The scale will accurately count pieces based on the unit weight entered.
1. Make sure the scale is on zero.
2. Press the UNIT WT soft key while the scale is on zero and empty.
3. You will be prompted to enter the Unit Weight of the item to be
counted. See screen below:
Decimal .
Enter Unit Weight
UNIT WEIGHT ENTRY
In Pounds
Decimal
point
soft key
Unit Weight
entry prompt
4. Key in the unit weight in pounds. Use the DECIMAL soft key to enter a
decimal point. Press enter to accept the entry. Press clear to erase
entry.
5. When the input is accepted, the scale is ready for counting.