Tuffy Security 310 - Manual (Page 3)

Page 3 of 4 – 12/9/2011 – Rev 12/14/11
FIGURE 3
5. Lay down the rear seats and remove the (2) Forward OEM Cargo Tie Downs(located on the floor near the rear seat
mount brackets). Place the #2 Front Panel into the vehicle so that the panel leans toward the rear of the
vehicle(similar angle as the seatbacks when up). Reinstall, but do not tighten the OEM bolts into the Cargo Floor(See
Figure 4). NOTE: It is possible to reuse the Cargo Tie Downs, but it is much easier to install the Front Panel if the
OEM Tie Down Loops are set aside(to be returned/reused if the 310 Tailgate Enclosure is removed).
FIGURE 4
6. Install the #1 Lid Assembly with trim pieces into the vehicle by positioning the rear side flanges under the hardtop
mounting lip at the rear of the vehicle body and tilting the #1 Lid Assembly downwards to meet up with the #2 Front
Panel. The #1 Lid Assembly is intended to lap over the front of the #2 Front Panel.(Figure 5) NOTE: This step is
difficult for a single person, and should be done with a second person.
***Note: If installing the #310 Tailgate Security Enclosure on a vehicle with a softtop, it will be easier to remove the (2)
softtop rear window bar clips located to either side of the tailgate. Once the #1 Lid is properly installed, the clips can
be re-installed by pressing the lid downwards and attaching the clips under the body lip.