Tuffy Security 310 - Manual (Page 4)

Page 4 of 4 – 12/9/2011 – Rev 12/14/11
FIGURE 5
7. Adjust the #2 Front Panel so that the gap between it and the forward flanges of the #1 Lid Assembly is minimized and
install (4) #10.4.1 carriage bolts from the front of the installed enclosure. Install (4) #10.4.3 washers and the (4)
#10.4.2 wing knob nuts from inside the enclosure. The two panels have slotted mounting holes to allow for the
tailoring the fit of the enclosure. NOTE: It may be necessary to raise or lower the #1 Lid to provide a better seal to the
carpet in the cargo area. (Figure 6)
FIGURE 6
8. Tighten the (4) #10.4.2 Wing Knob Nuts securing the #1 Lid Assembly and #2 Front Panel, then tighten the OEM
Cargo Tie Down Bolts to further compress the carpet in the cargo area.
Call (970)564-1762 for Technical Support