USL JSD-60 Manual - Manual (Page 56)

Page 56
Appendix D – JSD-60 Accessories
AES/EBU RJ45 Adapters for various servers
The JSD-60 can use CAT5 cable with RJ45 connectors to carry AES/EBU audio from the digital cinema server to the
JSD-60. Use of CAT5 cabling reduces cost and simplifies the installation. EBU Tech. 3250-E, third edition, states that
AES/EBU may be carried over CAT5 cable for 400 meters.
To simplify the use of CAT5 cable for AES wiring, USL makes the following adapters available. These plug into the
DB25 connector on the server. CAT5 cables can then be run to the JSD-60.
Dolby® DSS-200
USL JSD-RJF8
Adapter has DB25F wired with DMA8 pin out and RJ-45 jack.
Doremi DCP2000
USL JSD-RJMI
Adapter has DB25M wired as per SMPTE EG DC28.307-3103B DRAFT (2004, never adopted) and RJ-45 jack.
GDC IMB (25 pin D)
USL JSD-RJMI
Adapter has DB25M wired as per SMPTE EG DC28.307-3103B DRAFT (2004, never adopted, same pin out as JSD-60
DB25) and RJ-45 jack.
Sony SRXR320P
USL JSD-RJM8
Adapter has DB25M wired with DMA8 pin out and RJ-45 jacks.
JSDV-80 Remote Volume Control
The JSDV-80 remote volume control is connected to the JSD-60 using the automation interface. The JSDV-80 is
typically located in the auditorium.
MMP-10
Microphone multiplexer system to drive JSD-60 RTA with four multiplexed microphones as per SMPTE 202-2010
section A.4a.
DAT-100
DAT-100 Digital Audio Generator generates tone, voice, and pink noise signals on 16 AES/EBU channels. The DAT-
100 can be used to adjust the JSD-60 bypass crossovers.
VP-1
Vent panel to fill the space and provide ventilation above and below the JSD-60.