USL DAX-602 - Manual (Page 16)

DAX-602/802
INSTRUCTION MANUAL Ultra Stereo Labs, Inc.
- 16 -
Analog Output Connector: (25 pin D sub Male) (Balanced or Unbalanced Line)
Note: In Unbalanced mode the negative signal MUST be connected to ground.
To minimize ground loop hum, the negative side of the output should be connected
to ground at the signal desination instead of at the DAX. Twisted pair shielded
cable should be used.
HI/VN-N Output Terminals: Hearing impaired audio and visually impaired narra-
tion audio are available on a terminal strip on the rear panel of the DAX. These
outputs can drive balanced or unbalanced loads. When driving unbalanced loads,
connect the negative output of the DAX to ground at the destination end of the
cable to minimize ground loop hum. Use twisted pair shielded cable to carry the
HI/VI-N audio to the transmission equipment (such as the USL IRC-28(C)).