VICI D-4-I-TQ-R - Manual (Page 13)

9
Detector Electrical Connections
CAUTION: Do not use a wrench to tighten the SMC
connectors on the bias and electrometer cables.
Connections should be finger tight only.
1. Referring to Figure 5 as necessary, connect the BIAS cable to the top
electrode and the electrometer cable (ELECT) to the bottom electrode.
2. Connect the high-voltage cable from the detector to the pulse supply.
Installation
PULSER
MODULE
ELECTROMETER CABLE
BIAS CABLE
ELECTROMETER
BOARD
Figure 5: Schematic of electrical connections