Installing sfp modules into sfp module slots, Align the sfp module in front of the slot opening – Cisco 3560 User Manual

Page 48

Advertising
background image

2-16

Catalyst 3560 Switch Hardware Installation Guide

OL-6337-07

Chapter 2 Switch Installation (24- and 48-Port Switches)

Installing and Removing SFP Modules

Installing SFP Modules into SFP Module Slots

Figure 2-13

shows an SFP module that has a bale-clasp latch.

Figure 2-13

SFP Module with a Bale-Clasp Latch

Caution

We strongly recommend that you do not install or remove fiber-optic SFP modules with cables attached
because of the potential damage to the cables, the cable connector, or the optical interfaces in the
SFP module. Disconnect all cables before removing or installing an SFP module.


Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP
modules more often than is absolutely necessary.

Step 1

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

Step 2

Find the send (TX) and receive (RX) markings that identify the top side of the SFP module.

Note

On some SFP modules, the send and receive (TX and RX) markings might be replaced by arrows
that show the direction of the connection, either send or receive (TX or RX).

Step 3

Align the SFP module in front of the slot opening.

Step 4

Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear
of the slot. (See

Figure 2-14

.)

Figure 2-14

Installing an SFP Module into an SFP Module Slot

86575

40

41

42

43

44

45

46

47

48

47X

48X

Catalyst 3560

SERIES

PoE-48

1

2

3

4

97928

Advertising