Vogelzang TR002 - Manual (Page 5)

VGZ-027 / 20120209.1 TR002 SHILOH™ / Page 5
ASSEMBLY INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED
FOR INSTALLATION
tools
• Pencil
• 6 foot Folding Rule or Tape Measure
• Tin Snips
• Drill: Hand or Electric
• 1/8” dia. Drill Bit (for sheet metal screws)
• Screwdrivers (blade and Phillips type)
• 5/16 inch Nut Driver or Ratchet with 5/16 inch Socket
• Safety Glasses
• Gloves
materials
(NOTE: The following items are NOT included with your stove)
Flooring Protection: 36” x 48” as specified (see page 7)
Chimney Connector Pipe: 6” dia. minimum 24 MSG black or 26
MSG blue steel straight stove pipe or elbow(s) as required.
1/2” Sheet Metal Screws
Chimney: Existing 6” Code-approved Lined Masonry Chimney or
6” Inside Dia. Listed Type HT manufactured chimney.
Furnace Cement (manufacturer recommends Rutland Code 78
or equivalent)
CAUTION: STOVE IS HEAVY. MAKE SURE YOU
HAVE ADEQUATE HELP AND USE PROPER
LIFTING TECHNIQUES WHENEVER MOVING
STOVE.
1. Uncrate the stove and remove all cardboard and
styrofoam packing materials and protective poly
bag. Remove pedestal base, sides, front, top, ash-
drawer and ash drawer support from the carton.
(Save packing materials for further assembly.)
NOTICE: DO NOT remove ceramic blanket material
from inside stove pipe opening (Fig. 1).
4. Attach the pedestal front frame to the sides. The
pedestal front should go over (not inside of) the side
panels. Use three (3) self-tapping screws (provided
in the hardware pack) on each side to attach both
pedestal sides (#15) to the pedestal front (#17).
5. Position ash drawer support into assembled ped-
estal (Figure 5) and secure from rear with two (2)
machine screws, lockwashers and hex nuts. Tighten
all pedestal hardware.
2. Remove parts and hardware pack located inside
firebox.
Figure 2 – Pedestal
Assembly Hardware
sheet metal screws, 5/16˝
machine screw, lock
washer & hex nuts
Figure 3 –
Assemble
sides to base
Figure 4 – Attach Pedestal
Front Frame to Sides.
(Note– front goes OVER
the side panels.)
Figure 1 – DO NOT remove ceramic blanket from
inside stove pipe opening. This is NOT packing
material but an integral component of the stove
combustion system.
NOTICE: Vogelzang International Corp. grants no warranty, stated or implied, for the installation or
maintenance of your wood stove and assumes no responsibility of any incidental or consequential damages.
3. Align the hole pattern of one of the pedestal sides
to the holes in the base and secure with four (4)
machine screws, lock washers and hex nuts. As-
semble the opposite side to the base. (Note: Sides
are interchangable)
continued on next page