Winco ASCO 300 H Design 600-1200 Amp - Manual (Page 17)

Fast/Slow Adjust
Daylight Saving
Time Adjust
Date
Time
Start TIme
Engine Exerciser
Run TIme
CONTROL FEATURES (continued)
5---3
How to Set Optional Programmable Engine Exerciser (part of Acc. 11BG module)
Hazardous voltage capable of causing shock,
burns, or death is used in this transfer switch.
Deenergize both Normal & Emergency power
sources before programming the exerciser.
Navigating the Menu
Use the UP and DOWN arrow
keys to move through the displays.
Changing the Parameters
Use the UP and DOWN arrow
keys to move though the displays
to the parameter to be changed.
Push the ENTER key to start the
editing
process. The first
parameter will flash. Use the UP
and DOWN arrow keys to adjust
the parameter to the desired
value and press the ENTER key
to save the value. The next
parameter will now flash. Repeat
the process until each parameter
is properly configured.
Engine Exerciser Display
The Engine Exerciser Display
shows the status of the engine
exerciser. When the unit is shipped from the factory the
programmable engine exerciser is “Disabled” and must be
set to “Enabled” by the customer. When the engine
exerciser is running, this display will count down the
remaining time until the end of the exercise period.
Start Time Display
The Start Time Display shows the engine exerciser start
time. There are four parameters that determine the start
time:
weekly (”Every”) or bi–weekly (”Alt”) operation
day of week (”Sun” through “Sat”)
start hour (0 through 23)
start minutes (0 through 59)
For example, if the user wants the exerciser to run every
other Saturday at 3 PM, the proper configuration would
be:
“Alt Sat @ 15:00”
NOTE: When choosing bi–weekly operation, the
exerciser will always run on the week designated “(1)” on
the date display.
Run Time Display
The Run Time Display shows the run time for the engine
exerciser. The default setting from the factory is 30
minutes.
Time Display
The Time Display shows the present system time. The
format is “hours:minutes:seconds”.
NOTE: During total power outages, power to the
accessory is maintained by a battery in the Controller (see
page 4–2). Be sure that the 9–volt alkaline battery is fresh
and enabled (jumper in ON position) so that the time and
date settings are not lost.
Date Display
The Date Display shows the present system date. The
format is “day of week (week) month/day of month/year”.
NOTE: Week is either week 1 or week 2. This is used in
conjunction with the bi–weekly timer.
Daylight Savings Time Adjust Display
This display shows whether the automatic daylight saving
time adjustment is active. The factory default is “NO”. If
enabled, the unit will automatically adjust for daylight
saving time at 2 AM on the first Sunday of April and the
last Sunday of October.
Fast / Slow Adjust Display
This display shows the automatic fast/slow adjustment
value. The factory default is 0. This feature can be used to
trim a clock that runs fast or slow. For example, if your
clock runs 10 seconds slow per week, change the fast/slow
adjust value to “+10” and the unit will automatically add
10 seconds to the clock every week.
NOTE: Adjustments are made Sunday morning at 2 AM.
If you want your exerciser period to start at 2 AM on
Sunday, you cannot use this feature and the adjustment
must be set to 0.
Fill in your settings for future reference
Weekly or Bi–weekly Day of Week Start Time Run Time
Every = weekly
Alt = bi–weekly
Sun through Sat
0 – 23 hour
0 – 59 minute
0 – 23 hour
0 – 59 minute
30 min. is default setting
Date exerciser was set ______________________________________