Winco ZTX-RM Series 40-400 Amps - Manual (Page 8)

■ ■ 6 GE Zenith Controls ■ ■ ZTX-RM Operation and Maintenance Manual (62R-2000)
RM 4 Control Interface ( Optional )
Optional Pushbuttons
F. Generator Start/Stop push button. Pressing and
holding this button for approximately 5 seconds
will cause the generator to start. Pressing this button
a second time will stop the generator.
G. Exerciser Start/Stop push button. When this button
is depressed it will enable the automatic exerciser
mode. Pressing this button a second time will cancel
the automatic exerciser mode.
H. Reset push button. Pressing this button will clear the
fault indications.
I. Transfer push button. Pressing this button will force
the unit to transfer from one position to another when
both sources are available.
A
H
B
I
C
D
F
G E
Optional Indicator LED s
Utility available Green LED. When on, indicates the
utility source is acceptable.
Utility position Green LED. When on, indicates that
the transfer switch is connected to the utility.
Generator available Red LED. When on, indicates
the generator source is acceptable.
Generator position Red LED. When on, indicates that
the transfer switch is connected to the generator.
Load Amber LED. When on, indicates that the load
is connected to an acceptable source.
Figure 5
A
B
C
D
E
F
G
H
I
DANGER
HAZARDOUS VOLTAGE
(Can Cause Severe Injury or Death)
Turn OFF all power before installation, manual operation or removal of transfer switch or any of its components.
Connecting Engine Start may cause Generator to start. Before connecting, turn Generator OFF.