YSI 95 - Manual (Page 14)

Operation Section 4
YSI Incorporated Model 95 10
through the saved sets of data.
4. Depress the DOWN ARROW button to move down through the saved sets of data.
5. When you have finished recalling data, press MODE two times to return to normal operation.
NOTE: The Model 95 will recall data as a list. When the UP ARROW is depressed the Model 95
will display the Site ID# for the previously recorded date. For example: If you are reviewing Site
ID# 5 and the UP ARROW is depressed the Model 95 will display Site ID#4. If you are reviewing
Site ID# 5 and Site ID# 5 was the last set of data stored the DOWN ARROW button will display
Site ID# 1.
Here is an example of the Model 95 memory.
Site ID #1
Site ID #2
Site ID #3 If the UP ARROW button was pressed the Model 95 would display Site ID #2
Site ID #4
Site ID #5
4.7 4.7 4.7 4.7 ERASING STORED DATA ERASING STORED DATA ERASING STORED DATA ERASING STORED DATA
1. To erase the data that is stored in the Model 95’s
memory, depress the MODE button until the
Model 95 displays ErAS on the screen.
2. Depress and hold the DOWN ARROW and
ENTER buttons simultaneously for
approximately 5 seconds.
3. When the Model 95 has successfully erased data,
the display reads DONE for 1 to 2 seconds. The
instrument will automatically change to normal
operation after completion and the next saved
data will be stored in site ID# 1.
IMPORTANT: Using the erase function forever and completely erases data in all 50 site
ID’s. Do not use the erase function until all recorded data has been transcribed to an archive outside
the Model 95.
ErAS