Philips LP2PB201CS User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the hardware
STEP 1
Choose a comfortable and secure location for the Light Probe unit, making sure that
the interconnection cables can reach both the monitor and the computer. Check that
either the device or the cables will not interfere when you tilt and swivel your moni
tor.
C
au
Y
io
N: do not place the Light Probe unit on top of your monitor.
If you obstruct the air flow coming from the cabinet ventilation slots both the moni-
tor and the Light Probe unit can be damaged by excessive overheating.________________
CAuTloN:
To prevent possible damage to equipment, both the computer and moni-
tor must be turned off before connecting or disconnecting any cable.
When connecting a cable, perform the operation carefully making sure that con-
nectors are well aligned during insertion._____________________________________
STEP 2
Connect the cable having the 9 pin D - subminiature plug in type connector (male)
to the connector labeled SERIAL INTERFACE located on the back of your monitor.
STEP3
Connect the other end of the cable to the output port of the Light Probe unit, which
is marked as follows on the bottom of the unit:
9
Gettin started