Philips AZ1060 - Manual (Page 16)

BASIC FUNCTIONS GENERAL INFORMATION
Switching on and off
1. Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE/ off
-'The respective function indicator: cd , tuner or tape lights up.
2. To switch off, adjust the POWER slider to TAPE/ off position
with the keys on the tape deck released.
— The respective function indicator: co,
tuner or tape goes out.
— The volume and tuner presets will be retained in the set's
memory.
Adjusting volume and sound
1. Turn VOLUME to the desired level.
2. Adjust the DBB control to select dynamic bass boost on or off.
PHILIPS demo mode
1. Press the CD STOP ■ button for 5 seconds.
— After about 30 seconds, PH..IL ..IPS scrolls across the display.
2. To return to the current display you can either:
• press any function button on the front panel. This interrupts
the demo mode for 30 seconds;
• press the CD STOP ■ button for 5 seconds. PH..IL ..IPS
scrolls once before the demo mode is cancelled.
GENERAL INFORMATION
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.
Safety information
• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
Tl
/.
2.1
3.
4.\
• 1
r
To
- F
a
c
- F
tf
tl
5.T(
VI
-T
Proi
You
/.Tl
2. Pi
- Di
J.Pr
1
4. Pr
- Di
fri
5. Re
- Yo
its
Tunii
Press
dispic
10