Philips AZ1060 - Manual (Page 23)

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the warranty.
"oi
PROBLEM
- POSSIBLE CAUSE
• REMEDY
No sound/power
Poor radio reception
nl~ d tSC indication
VOLUME not adjusted
• Adjust the VOLUME
- Headphones connected
• Disconnect headphones
- Power cord not securely connected
• Connect the power cord properly
- Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Severe radio hum or noise____________ ___
- Electrical interference: set too close to TV,
VCR or computer
• Increase the distance
CD-BIWj is blank or the disc is not finalized
Use a finalised CD-R(W)
CD badly scratched or dirty
Replace/ clean CD, see Maintenance
The CD skips tracks
CD is damaged or dirty
Replace or clean the CD
SHUFFLE or PROGRAM is active
Quit SHUFFLE/PROGRAM mode(s)
Poor cassette sound quality * •
- Weak radio signal
• EM: Direct the FM telescopic antenna for
optimum reception
• AM: Turn the set for optimum reception
no d ISC or (!_ id Err indication
- l\lo CD inserted
• Insert a CD
- CD badly scratched or dirty
• Replace/clean CD, see Maintenance
- Laser lens steamed up,
• Wait until lens has cleared
- Dust and dirt on the heads, etc.
• Clean deck parts etc., see maintenance
- Use of incompatible cassette types (METAL
or CHROMEI.
• Only use NORMAL (lEC I) for recording.
Recording does not work______________________
- Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space.
The type plate is found on the bottom of the set.
17