Philips MX3690B - Manual (Page 33)

S etting the R emote to W ork
VCR
s ( continued )
A Tow that you have looked up
X V the two-digit Remote Code
Number for your brand of VCR
(on previous page), you are
ready to follow the four simple
steps below.
Please read through steps 1-4
before beginning.
C beoin J
Press and release the REC
I (RECORD) button.
Within thirty seconds after
releasing the REC button, press
and release the VCR System
button.
Within thirty seconds after
releasing the VCR System
button, ENTER THE TWO
DIGIT CODE NUMBER for
the desired VCR. The remote is
now ready to send commands to
the VCR.
Point the remote at the VCR.
Press the POWER button on the
remote to turn the VCR ON.
S m ARl Hl l.l*
Try it out. The Channel
% and VCR buttons on the
remote should now operate the
VCR.
Remember, if this doesn't work
the first time, repeat steps using
the same remote code number.
If after a second try the remote
does not operate your VCR, and
there are more code numbers
listed for your brand VCR, use the
next listed code number.
If after repeated attempts the code
number method does not work
your VCR, try the "VCR
SEARCH" method on page 36.
Pi p
VOL CH
o o
(ON/OWli WS H SWAP M «gg 1
azT
33