Installing the speakers on the wall – Sony HT-DDW675 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the speakers on the
wall
You can install your front and surround speakers
on the wall.
1
Prepare screws (not supplied) that are
suitable for the hole on the back of
each speaker. See the illustrations
below.
f
\\\\\\\\\\\\\\I>4------------------------- than 4 r
\J.............................
f
(5/32 inch) (5/32 inch)
\>------------ »1
more than 25 mm (1 inch)
Notes
• Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a beam and fasten them
to the wall. Install the speakers on a vertical and flat
wall where reinforcement is applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
4.6 mm
(3/16 inch)
10 mm
(13/32 inch)
2
Hole on the back of the speaker
Fasten the screws to the wall. The
screws should protrude 5 to 7 mm (7/32
to 9/32 inch).
3
Hang the speakers on the screws.
Hole on the back of the speaker
14
US