CITIZEN CLP-2001 - Manual (Page 26)

2.4 Printer Setup Mode
The printer enters the printer setup mode when both Stop and Feed
keys are pressed simultaneously. The control key functions at this time
are described below.
Settings of the printer setup mode are stored in nonvolatile memory, so
once they are set, they are remained even when the power is turned off.
[Functions]
Set the print mode seiection, peeling sensor ON/OFF, auto-cutter
ON/OFF etc.
■ Pause key; Selects the mode.
■ Feed key: Selects the mode item.
■ Stop key: Saves settings and returns the printer to normal
operating mode.
Item
--------- ;
Direcl-thermal/thermal-
transfer printing
I
Peeling sensor
i
Auto-cutter
4
Tearing
4
Sensor selection
____ _l
LCD indication
Direct TM — Transfer
Peel OFF Peel ON
Cut OFF Cut ON
Tear OFF -*■ Tear ON
Edge -* Reflect -- Continu P ■
2.5 Self-Test Mode
The printer enters the self-test mode when the Feed key is pressed and
held down while turning the printer on.
[Functions]
The printer performs the test print and enters the data dump mode (prints
communication data with ASCII codes). The printer returns to the riormal
operating mode when the power is turned off.
If the Feed key is pressed further for five seconds after the printer has
entered the self-test mode, the test print will be performed in the continuous
paper mode, regardless of sensor selection stored in backup memory.
2-4