4 ribbon feed troubleshooting – CITIZEN CLP-2001 User Manual
Page 47
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4.4 Ribbon Feed Troubleshooting
Problem
Cause and remedy
Ribbon is not wound.
Ribbon path is wrong.
-> Use the proper path.
Direction of ribbon winding isSet it to the right winding
reverse.
direction.
Tension of ribbon winding is
not proper.
Set it properly.
Printing continues even If
ribbon is out.
Print mode is the direct-
thermal.
Set It to the thermal-transfer
if necessary.
Ribbon wrinkles.
Tension of the ribbon holder
and winder is not proper.
Print density (heating factor)
is not proper.
Angle of ribbon guide bar is
not correct.
Set H properly.
Correct the parameter of the
Hnn command in the
printing contents definition
mode.
Adjust the ribbon guide bar.
Contact our service
personnel. Note: If a
narrow paper is used, the
ribbon may wrinkle. To avoid
this, decrease the right head
pressure with the head
pressure adjust-screw.
4-9