Sears 71381 - Manual (Page 13)

REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when
installing or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pair of rack
guides.
2. Push the rack In until you reach the bump In the rack
guide, then lift the front of the rack a bit and push the
rack all the way in.
To remove;
1. Pull the oven rack out, then up.
The racks are designed with stop locks so when
placed correctly on the shelf support, they will
stop when extended from the oven and will not
tilt when food is removed from or placed on them.
REMOVABLE OVEN BOTTOM
The oven bottom in your range can be removed for
easier cleaning.
Be careful not to scratch the oven finish when
removing or replacing the oven bottom.
To remove:
1. Grasp oven bottom at finger slots on each side.
2. Lift the front edge of the oven bottom enough to raise
the tabs from the slots in the front frame.
3. Push the oven bottom back about 1/4" to release the
flange from the front frame, then pull out.
To replace:
1. Slide the oven bottom Into the oven so the back tabs
fit Into the slots In the oven back.
2. Grasp at finger slots and push the oven bottom back
and then down to hook the flange under the front
frame.
3. Fit the front tabs into the slots In the front frame.
SLOT IN
OVEN BACK
RNGER
SLOT
SLOT IN
FRONT FRAME
FLANGE
REMOVABLE ROLL-OUT BROILER
To remove the roll>out broiler for easier clean*
ing:
1. Pull broiler out until it stops, then push back in about
1 inch. ’
2. Grasp handie, ilft, and puil broiler out (lift the rollers
under the broiler over the roller guide stops in the
range).
To replace broiler:
1. Put the rollers under the broiler behind the roller
guide stops in the range.
2. Hold broiler in the raised position as you slide it part
way into the range, then lower broiler and push
completely closed.
12
NGMNT09-2