Materials and basic tools needed, Materials needed, Basic tools – Sears KENMORE POWER MISER 153.336431 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials and Basic Tools Needed
Materials Needed
To simplify the installation Sears has available the installa
tion parts shown below. You may or may not need all of
these materials, depending on your type of installation.
COMPRESSION COUPLINGS
FOR CONNECTING TO
COPPER PLUMBING WITH-
OUTSWEAT SOLDERING
WATER HEATER
INSTALLATION KIT WITH
FLEXIBLE CONNECTORS FOR
3/4" GALVANIZED OR
l/2"COPPER PLUMBING
i
VENT ELBOW
EXPANSION TANKS FOR
THERMAL EXPANSION
conditions
AVAIL
ABLE IN 2 GALLON AND
5 GALLON CAPACITY
THROUGH LOCAL
SEARS SERVICE CENTERS.
WATER HEATER STAND 24“x24"x18"
FOR USE WITH WATER HEATERS INSTALLED
IN RESIDENTIAL GARAGES HAVING A DIAM
ETER 24" OR LESS AND A RATED CAPACITY
75 GALLONS OR LESS
HEATER CAS CON
NECTOR WITH
FITTINGS
VENT EXTENSION
Wat«r Heater
Heat Trajïs
WATER HEATER HEAT TRAPS
HELP REDUCE HEAT LOSS DUE
TO THERMAL SYPHONING
WATER HEATERS HAVING A DIAMETER 18”
OR LESS AND AVAILABLE IN 28“ DIAMETER
FOR WATER HEATERS HAVING A DIAMETER
26" OR LESS
Basic Tools
You may or may not need all of these tools, depending on
your type of installation. These tools can be purchased at
your local Sears store.
Pipe Wrenches (2) 14"
Screwdriver
Tin Snips
6 Foot Tape of Folding Ruie
Garden Hose
Drill
PIPE
WRENCH
ROLL OF TEFLON TAPE
(USE ONLY ON WATER
CONNECTIONS)
PIPE DOPE (SQUEEZE TUBE)
(USE FOR WATER AND CAS CONNECTIONS)
ADDITIONAL TOOLS NEEDED
WHEN SWEAT SOLDERING
Tubing Cutters or Hacksaw
Propane Torch
Son Solder
Solder Flux
Emery Cloth
Wire Brushes
HACKSAW
3/4“ WIRE BRUSH
1/2" WIRE BRUSH
ROLL OF LEAD FREE
SOFT SOLDER
ií3
PROPANE TORCH
ROLL OF EMERY
CLOTH
SOLDER FLUX TUBING CUTTER