Sears KENMORE 385. 12708 - Manual (Page 12)

SECTION 2. PREPARE THE MACHÍNE FOR SEWING
Prepare the Top Thread
• Thread the Needle
The numbered steps above follow the numbers
on the illustrations.
Dotted lines show places where the thread
loops and then is pulled tight.
2. While holding thread near spool, draw thread down into the tension area and then around the
check spring holder.
3. Firmly draw thread up and through take-up lever from right to left.
4. Draw thread down and slip it into left side needle bar thread guide.
5. Thread needle from front to back.
NOTE: You may want to cut the end of thread with sharp scissors for easier needle threading.
11