Zigzag stitches (continued), Ipiuui – Sears KENMORE 385. 12708 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3. LEARN THE STITCHES
Zigzag Stitches (Continued)
• Sew a Button
/----------------------------------------
Set the Machine
Stitch
Stitch selector
lllllltia
IPIUUi,
Top thread tension Stitch length control
control 1 to 4
any
number (not
necessary to adjust)
I
-3-
Zigzag foot
Darning plate
Use the darning plate for button sewing (see p. 22).
1.
Set the stitch selector at " ci=> "■
2.
Align both holes of the button with the slot of the foot and place the left
hole of the button just below the needle point.
3.
Lower the foot and turn the stitch selector to zigzag until the needle point
comes just above the right hole of the button.
4.
Sew about five stitches and raise needle.
I
5.
Set the stitch selector at " c'^ " again and sew a few stitches to lock thread.
To
strengthen
the
shank,
cut
the
threads leaving a 20 cm (8") tail. Bring
the
needle
thread
down
through
the
hole in the button and wind it around
the shank.
Draw
the
thread
to
the
bottom
side
and knot.
26