Sears 385 - Manual (Page 14)

SECTION 2. PREPARE YOUR MACHINE FOR SEWING
• Pre»er Foot Types
Zigzag Foot Straight Foot
To Snap On
1. Place the presser foot so the hori­
zontal pin on the foot lies just
under the groove of the foot
holder.
2. Lower the presser foot holder to
lock the presser foot in place.
NOTE; If you do not hear the
presser foot snap in place,
press down on the presser
foot holder firmly until you
hear the snap.
Stitching.
Uses: Zigzag stitching (see page 31),
Bar tacking (see page
Button sewing (see page
Rick-rack stretch (see page 36),
Three-step zigzag (see page 37),
Overcast stretch (see page 38),
Lace work (see page 40),
Two-point shell stitching
(see page ^),
Smocking (see page ^),
Stretch patching (see page 51),
Fagoting (see page 52),
Herring bone stretch (see page 52),
Elastic stretch (see page 53),
Box stitching (see page ^),
Two-point box stitch (see page 54),
Overedging stitch (see page 54).
Use this foot exclusively for straight stitching
using center needle position only.
Uses; Straight stitching (see page ^),
Topstitching (see page 29).
Straight stretch (see page 30).
11