Sears 385 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2. PREPARE YOUR MACHINE FOR SEWING
Prepare the Bobbin
• To Remove the Bobbin from the Machine
• Wind the Bobbin
it towards VPU-
2.
Set aside.
3.
Lift out the bobbin, as shown.
2.
Pull the clutch away from the machine to stop the needle from moving while you
winding the bobbin.
3.
Draw thread from spool through bobbin winder tension disc as shown,
4.
Place the threaded bobbin on the bobbin winding spindle so that the thread comes
out on top,
5.
Push the bobbin winder spindle to the right until it clicks.
6. Holding onto end of thread, depress the foot control.
7. When the bobbin is slightly filled, stop the machine and clip the thread coming from
the bobbin,
8.
Slowly start the machine again and wind the thread until the bobbin stops.
9.
Push the bobbin winder spindle to the left and clip the thread.
10.
Remove the bobbin.
11.
Push in the clutch for normal sewing operation.
15