Sears OVERLOCK 3/4D 385.16631 - Manual (Page 16)

■•SECTION' O. . :"'PREPA'RE YOUR'IVrACHINE FOR SEWING
10
( 4 ) Insert the thread between tension
discs from the right. Then pul!
both sides of the thread firmly
between tension discs.
@ Pass the thread through lower
looper thread guide <1).
@ Pass the thread through lower looper thread
guide (2).
( 7 ) Pass the thread through the looper thread
take-up lever (lower).
@ Pass the thread through lower looper thread
guides (3) and (4).
Turn the hand wheel toward
you
until the lower looper
comes to the right, and pass the
threader through hole on lower
looper thread guide (5).
Hook the end of thread on the
threader. (See Note.)
Thread-
@) Pull the threader to pass the
thread through the hole of
lower looper thread guide (5).
Remove the thread from the
threader, and draw the thread
through the hole on lower
looper to the back 10 cm (4")
or more with a pair of tweezers.
NOTE: How to Thread Woolly Nylon/Polyester Thread.
F
Tension discs
* Make sure that the thread is between
the tension discs.
NOTE: If you remove the needle plate, the threading points
of lower looper are easier to see.
In this case, make sure the thread is not caught by the
needle plate when replacing the plate after threading.
Shown above is one of the easiest ways to pass woolly nylon/
polyester thread through the needle.
Use the same method forthe upper looer. 11