Sears OVERLOCK 3/4D 385.16631 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the Machine
SECTION 2. NPREPAREYOUR MACHINE FOR SEWING
For your convenience, your Kenmore overlock has been pre-threaded. To prepare to sew with your
choice of threads, follow these simple instructions:
— Make sure unit is unplugged from the wall outlet and/or machine.
— Raise telescoping thread guide bar.
— Open looper cover.
— Place spool cones on spool holder.
— Tie farthest cone on the right to green, 2nd from right to red, 3rd from right to blue and remaining
spool on left to orange.
— Raise presser foot.
— Set tension dials to 0.
— Turn hand wheel away from you once or twice until needles are in the full up position. This
releases threads.
— Pull all threads out until either the orange or blue thread approaches the needle eye.
— Cut out needle thread knot and pull additional thread to thread needle.
— Pull thread until the remaining thread is close to the other needle eye.
— Thread needle.
— Pull thread until the knots have gone through the upper and lower looper.
— All threads should be under the presser foot and pulled to the back.
— Set all tension dials back to 3.
— Lower presser foot and tu rn hand wheel toward you to chain off 3 or 4 stitches.
— Plug unit in wall outlet and machine and turn power switch on.
~ You are ready to serge.
(Located behind looper cover)