Sears KENMORE 911.47466 - Manual (Page 9)

OVEN CONTROL CLOCK and KITCHEN TIMER
continued
TON£$
Your new control has a series of tones that will
sound at different times. These tones may
sound white you set the control for an oven
function, or at the end of the oven function It
will also alert you there maybe a problem with
the functions. Below are the types of tones
and a brief description of each.
TONÉS WHILB SETTINÚ THE
CONTROL
When you press a touch pad you will hear a
beep. This beep wiil let you know you have
placed enough pressure on the pad to
activate it.
END OF TIMED CYCLE TONE
At the end of a timed cooking function, you will
hear 3 short beeps followed by 1 beep every
6 seconds This 6 second beep will continue
to sound until the CLEAH/OFFpadis pressed
or you may select the special feature to cancel
this 6 second beep from sounding at the end
of future cycles.
TO GANCML TIfs 6 S»KUGN£f BEEP
1. Press and hold the BAKE and BROIL
pads, at the same time, until the
display shows "SF”.
2. Press the KITCHEN TIMER ON/OFF
pad The display will show “CON BEEP“
(continous beep).
3. Press the KITCHEN TIMER ON/OFF
pad again. The display will show “BEEP“
(beep canceled).
4. Press the START pad.
If you would like to return the 6 second beep,
repeat steps above until the display shows
your choice and press start.
/ijTENTtON TONE
This tone will sound if you make an error or an
oversight is made while setting an oven
function.
Examples would be.:
a. Setting a clean cycle and the oven door is
not closed properly
b. Setting a timed function and the time being
set is invalid-
c. Pressing an additional function pad
without first setting a temperature or time
Any of these can be quickly identified by
watching the display
■ 0 31 Mm> m M w W Hmm
When you set an oven temperature, the oven
automatically starts to heat. When the
temperature inside the oven reaches the
temperature you have set, a tone will sound to
let you know the oven is ready for baking.
FCODB
If you set an oven function and the control
beeps while the display is flashing
“F” and a
number “F-4” or letter “FI" there may be a
problem with the control Simply press the
CLEAR/OFF pad and wait about an hour. Try
setting the function again. If the code repeats,
write down the flashing code and call for
service. Tell the technician what the code
was flashing