SoundMax SM-CDM1032 - Manual (Page 12)

12
Functions of controls
General operations
Power button
Press any button to switch the unit on. The display will show a message “WELCOME”. Press
and hold the POWER button to switch the unit off. The display will show a message “GOOD-
BYE”.
Volume control
Rotate the VOL knob (VOL knob / SEL button) or press VOLUME+/- buttons on the RC. The
larger the number shown on the display, the higher the volume level is.
Audio settings adjustment
Press the SEL button (VOL knob) until the display shows: BAS 0 => TRE 0 => BAL R-L =>
FAD. Rotate the VOL knob to adjust each mode.
- BASS/TREBLE: -7, -6, -5,......, 0, +1, +2,......+5, +6, +7
- BALANCE: 7L, 11L,......, L=R, 1R,......,7R
- FADER: 7R, 11R,......, R=F, 1F,......, 7F
NOTE: Adjustments to Bass and Treble will override any preset EQ (Preset Equalizer
Curves).
In each mode, the waiting time is about 5 seconds, and the waiting time is over, it returns
to the last display mode of radio or disc playback mode.
Mode selection
Press the MODE knob to select the mode: AUX => RADIO => DISK => USB => CARD.
NOTE: USB, CARD, DISK mode will only show on the display when a USB flash memory is
inserted into the USB port.
Loudness control
Press the VOLUME knob / SEL button until “LOUD OFF” is shown. Turn the volume knob to
select between ON or OFF.